Monday 1 August 2016

Modified Dragoons, (Warlord) - Part 5 of 6

Although dragoons are normally only depicted with muskets they could also be armed with pikes (see the link in the original post). To represent this figure is portrayed as a pikeman using the ubiquitous plastic firelock figure from Warlord.

The arms were taken from a Perry plastics set (WoTR I think). Gaps in the shoulders were filled in with greenstuff. Using the same material the sleeve cuffs were also added. 
WIP
Looking at the figure in the state show above I kept on thinking that something didn't quite seem right. As the figure represents a pikeman I realised I had to extend the shaft. To do this I used a spare polearm.
Little tip: whenever you have to join two rods/bars of plastic together cut the shaft at a diagonal angle (45 degrees if you can, using the lines on your cutting board as a guide). this increases the surface area and helps form a stronger bond than the usual perpendicular cut.

No comments:

Post a Comment